IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres.
2. If possible avoid placing the appliance near cookers, radiators or in direct
GETTING TO KNOW YOUR LARDER FRIDGE
sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Cookers | 2" | (50 mm) |
From Radiators | 12" (300 mm) | |
From Refrigerators or Freezers | 1" | (25 mm) |
Allow a minimum of 60 mm (2.4 inches) between the top of the fridge and the ceiling or the underside of a wall cupboard.
3. Make sure that sufficient room is provided around the appliance to ensure free air circulation.
4. Fit the two plastic wall spacers supplied
with the appliance rotating 1/4 turn to the condenser at the back of the
refrigerator (see diagram). 5. The appliance should be located on a
smooth surface. The two front feet can be adjusted as required. To ensure that
your appliance is standing upright adjust
the two front feet by turning clockwise or
6.Refer to "Cleaning and Care" section to prepare your appliance for use.
7.This appliance has been designed to operate in ambient temperatures beetween +10 and +32 degrees C (50 and 90 degrees F).Therefore if the appliance is installed in an unheated / cold room (E.g.: Conservatory / annex / shed / garage etc.) then the food in the larder fridge [In particular salad, fruit, water and fruit juices] will start freezing because of the cold ambient temperature when the temperature drops below 0 C [Zero degrees Centigrade]. The appliance will resume normal operation when the ambient temperature rises back above +5 C. Please note, between 0 C and +5 C, the compressor will not run but the temperature in the larder fridge will be safe to store your food anyway. So don't worry when the compressor does not operate between 0 C and +5 C.
8.A special receptacle is supplied to store the mains plug during transit. The receptacle is fixed at the back of the
cabinet, on the right hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.
3
1
2
3
3
3
3
*6
4
5
7
8
Arrangement Examples (See diagram).
1.Interior light
2.Thermostat knob
3.Movable shelves
4.Defrost water collection channel - Drain tube
5.Crisper cover
6.Chiller drawer with humidity control
7.Crisper
8.Adjustable front feet
9.Adjustable door shelves
10.Egg compartment
11.Bottle shelf
9
10
9
11
9
9
11
6
7
