Beko TLDA 567 manual Above the compressor

STARTING

Final Check

Before you start using the refrigerator check that:

1.The front feet have been adjusted so the appliance is level.

2.The interior is dry and air can circulate freely.

3.Clean the interior as recommended under "CLEANING AND CARE."

4.Insert the plug into the wall socket and switch on the electricity supply. When the door is open the interior light will come on.

5.You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the compressor is running or not which is quite normal.

6.We recommend that you set the thermostat knob at 3 (three) and monitor the temperature to ensure the appliance maintains desired storage temperatures (See section Temperature Control and Adjustment).

7.Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the temperature with an accurate thermometer (see; Temperature Control and Adjustment).

Important Note :

Ice formation at the back is normal, do not worry. (See Defrosting)

DEFROSTING	2
The larder refrigerator defrosts	1
automatically. The defrosting water runs to
the drain tube via a collection channel (1)
and is evaporated in a special container
at the back of the appliance (see diagrams).
Ensure that the container is fixed properly	Special Container
above the compressor.

During defrosting water droplets may form
at the back of the larder refrigerator where
concealed evaporator is located. Some
droplets may remain on the liner and
refreeze when defrosting is completed. Do	Compressor
not use pointed or sharp edged objects
such as knives, forks to remove the droplets which have refreezed.

If at any time the defrost water does not drain from the collection channel, check to ensure that no food particles have blocked the drain tube. The drain tube can be cleared by pushing the special plastic plunger provided down the drain tube

(2).

10

CLEANING AND CARE

**We recommend that you switch off the larder refrigerator at the socket outlet and pull out the mains plug before cleaning.

**Never use any sharp instruments or abrasive substances, soap, household cleaner, detergent and wax polish for cleaning.

**Use luke warm water to clean the cabinet of the refrigerator and wipe it dry.

**Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water to clean the interior and wipe it dry.

**Make sure that no water enters the temperature control box.

**If the larder refrigerator is not going to be used for a long period of time switch it off, remove all food, clean it and leave the door ajar.

**Any dust that gathers on the condenser, which is located at the back of the appliance, should be removed once a year with a vacuum cleaner.

**Check door seals regularly to ensure they are clean and free from food particles.

**Removal of door rack :

•To remove a door rack, remove all the contents and then simply push the door tray upwards from the base.

**Make sure that the special plastic container (drain tray) at the back of the appliance which collects defrost water is clean at all times. If you want to remove the tray to clean it follow the instructions below :

•Switch off at the socket outlet and pull out the mains plug.

•Push the lug down with the tip of a screw driver & pull out firmly.

•Clean the drain tray and wipe it dry.

•Reassemble reversing the sequence and operations.

11