Beko WM 5100 S manual No water can

No water can	This is not a problem. The
be seen in
	water level is not visible
the machine
	from the outside of the
during
	machine.
washing.
	Water level might be
	above the lower level of	Run either the “Pump” or “Spin” program.
	the door.
	Machine might be heating
The door is	up the water or it may be	Wait until the process is over.
	at the spinning cycle.
jammed.
	Due to electrical safety
	mechanism, the door can
	only be opened a few	Wait until the process is over.
	minutes after the program
	has stopped.
Machine fills
with water	Inside of machine may be	For safety reasons, water should be cycled in
when a
	hot.	and out a couple times.
process is
cancelled.
		The machine will wait until there is a sufficient
	Water pressure may be	amount of water, which may lengthen the
	low.	washing time to avoid poor washing results due
		to insufficient water.
	Supply voltage may be	Washing time is lengthened to avoid poor
	low.	washing results when the supply voltage is low.
	Input temperature of	Cycle time lengthens to heat up the water when
		the input water is cold. Also, washing time can
	water may be low.
Washing time		be lengthened to avoid poor washing results.
		The automatic spin correction system might
takes longer
than the time		have been activated due to the unbalanced
specified in the		distribution of the laundry in the drum.
manual	There may be an	The laundry in the drum may be clustered
		(bundled laundry in a bag). Laundry should be
	imbalance of laundry in
		rearranged and re-spun.
	the machine.
		No spinning is performed when the laundry is
		not evenly distributed in the drum to prevent
		any damage to the machine and to its
		environment.
	Number of rinses and/	Water amount is increased to obtain a
	or amount of rinse water	better rinse and a rinse cycle is added when
	might have increased.	necessary.

27

EN