Balance Right: (available from the remote only)
Shifts balance right in 0.5dB steps. It is also used to scroll right in the setup menu.
MUTE:
The eVo2i starts up in Soft Mute. This level is 20dB below the displayed vol- ume level. When MUTE is first pressed it goes to the Soft state, pressing MUTE again within 3 seconds will fully MUTE the outputs.
ENTER:
This control button is pressed and held on the front panel or pressed 7 times on the remote to enter into the menu setting functions described below. It is also used to enter into specific modes within the menu system.
MAIN:
Cycles through the main inputs. It is also used to scroll to the left in the setup menu.
LOOP: (available from the remote only)
This is used to cycle through the inputs.
INPUT:
On the remote the Numbered Buttons (1-
5)allow you to select between the active inputs. From the remote, you can cycle through inputs using the LOOP button. From the front panel, you can cycle through inputs by pressing the MAIN button. When switching between inputs, the eVo2i will quickly ramp down the volume, switch inputs, then quickly ramp back up to the programmed volume set- ting.
PRESS ENTER AND HOLD TO | VOLUME CONTROL |
| |
AND UP/DOWN KEYS* | TAPE INPUT SELECT* | ||
ACCESS SETUP MENU* | |||
|
|
SOFT AND FULL | MAIN INPUT SELECT* | MUTES OUTPUT, DISABLES DISPLAY |
MUTE FUNCTIONS |
| AND CONTROLS |
*ALSO USED FOR NAVIGATING THE SETUP MENU
© | page 6 | eVo2i User’s Guide rev081104 |
