Bel Canto Design eVo2iTM Loudspeaker Connection, Setup Menu Options, A INPUTS CONFIGURATION Menu

Loudspeaker Connection

Connect loudspeakers to the outputs of the eVo amplifier using the 5-way binding posts located the rear of the amplifier. The red or black center plug in the output post can be removed for use with banana type connec- tors (all non CE countries). Do not connect speaker terminals to a ground connection.

The Anti-Phase operation of the outputs

would result in one of the red (positive) out- puts being connected to ground and cause the amplifier to go into protection mode and shut itself off.

Make certain that no connection from the output terminals is made to a chassis or earth ground.

Setup Menu Options

A) INPUTS CONFIGURATION Menu

This menu is used to customize the input options.

It is used to set:

1)Input Function

2)Input Name

3)Initial Volume level

4)Soft Mute level

1)The first level of this menu is used to set the INPUT FUNCTION. The options are Stereo or Disabled.

Change these settings by scrolling left or right to the desired input and pressing ENTER to change the setting. Use the UP/DOWN keys to scroll through the set- ting options. Disable unused inputs.

Press ENTER to exit this menu mode.

2)The second level of this menu is used for changing the Name of a given input.

To change an input name press ENTER and you will see an under-bar indicator for each of the 8 characters that can be used for naming the input. Scroll the indi-

cator left or right using the LEFT/RIGHT keys and use the UP/DOWN keys to scroll through capital and lower case let- ter, numbers 0-9 and a SPACE.

You can use the SPACE to separate words and numbers or to center short names like CD. Press Enter to exit this menu mode.

3)The third menu level is used to set the Initial Volume level.

Press ENTER and use the UP/DOWN keys to set the default level when coming out of STANDBY. Press ENTER to exit this menu mode

.

4)The fourth menu level is used to set the Soft Mute Level.

This is preset to -20 dB. This is generally a good soft mute level.

If you wish to change this for a given input then press ENTER and use the UP/DOWN keys to scroll to a different setting.

Press Enter to exit this menu mode.

© 2002-2004 bel canto design, Ltd. page 8 eVo2i User’s Guide rev081104