4.NEVERgrab or touch a live power cord (Figure 16) with wet hands,thepossibilityexistsof electricalshock,electrocu- tion and even death.
WET
HANDS
POWER
CORD
(POWER ON)
Figure 16. Power Cord (Wet Hands)
DANGER - Electrocution Hazard
NEVER grab or touch a live power cord. DO NOT stand in water when connecting the pump's power cord into a voltage source.The possibility exist of electrical shock, electrocution and possibly death!
3.If all of the pump's electrical requirements have been met, insert the power plug on the pump into the power source receptacle.
4.Wait a few seconds and water should begin to flow from the discharge hose.
5.If water is not flowing from the discharge hose or not flowing freely after a few minutes, remove the power from the pump and check the system for leaks.
ST-4125D/ST-6125D — OPERATION
Pump Shut-Down/Clean-up
1.Remove the power from the pump by turning off the circuit breakerorswitchthatprovidespowertothepump.Remem- bertomakesurethathandsaredry(notwet),andfeetarenot standinginwaterwhenremovingdisconnectingpowerfrom thepump.
2.Using the chain and lifting crane, lift the pump up from its current position. Remove the discharge hose from the dis- charge port on the pump.
3.Removeallpowercablesandfloatswitchesfromthecontrol box. Place cables and float switches in a suitable container where they will not get damaged.
4.Ifthepumpwasusedtopumpmud,gritorsilt,flush vigorously with clean water.
5.Removethepumpfromthewater.Wipeoffanymudordebris that might have attached itself to the pump.
6.Store pump in a clean dry place away from dirt and debris.
