Bench Dog Tools RT400 manual UE E To Loosen, Install the 2 insert plate hold-down screws

6.Adjust miter gauge track to fit your miter gauge. First test fit your miter gauge into the track. If it's too tight, squeeze the gib against the front wall of the miter track with a pair of Channel Locks, use a shop towel to prevent marring. Next, install the (14) 1/4-28 x 1/2" set screws. Tightening the screws will deflect the gib into your miter gauge. Tighten all screws uniformly and gradually until the desired fit is achieved.

	UEE
Q		Z
S			E

TO LOOSEN

1/4-28 x 1/2"	front	gib
set screw
	wall

This miter track ONLY fits standard 3/8" x 3/4" miter gauge bars. Wax the slot and bar to reduce wear.

7.Mount your router to the phenolic insert plate. This insert plate is undrilled. You must drill your own router mounting holes. Please reference the included

template to complete this step.

6

7

Router not included!

8.Adjust the leveling screws until the insert is flush. Install the insert plate and adjust the leveling screws until the plate is flush with router top. Fine adjust the six screws at the four corners of the insert opening first.

9. Install the (2) insert plate hold-down screws.

The (2) 1/4-20 x 1" phil. flat head machine screws prevent side to side movement, as well as keep the plate firmly seated. Readjust the plate flush if necessary. Tighten the hold-down screws before every use, if necessary!

1/4-20 x 1" phil. flat head machine screw

Page 5

8

9

Page 5