BENDIX EC-60 ABS-ATC STD-PREM CONTROLLERS manual Traction Control Valves

Troubleshooting Diagnostic Trouble Codes:

1st. Blink

Code

Traction Control Valves

Location

18 Traction Control Valve

2nd.	Diagnostic
Blink	Trouble Code	Repair Information
Code	Description
1	TCV Solenoid	Verify 7 to 19 ohms between TCV and TCV common. Verify no continuity between
	Shorted to	TCV leads and ground. Check for corroded/damaged wiring or connectors
	Ground	between ECU and TCV.
2	TCV Solenoid	Verify 7 to 19 ohms between TCV and TCV common. Verify no continuity between
	Shorted to	TCV leads and voltage. Check for corroded/damaged wiring or connectors
	Voltage	between ECU and TCV.
3	TCV Solenoid	Verify 7 to 19 ohms between TCV and TCV common. Check for corroded/
	Open Circuit	damaged wiring or connectors between ECU and TCV.
4	TCV	The ECU is not configured for ATC, but has detected the presence of a TCV.
	Configuration	Verify TCV wiring. Inspect for the presence of a TCV. Verify ECU configuration.
	Error

Traction Control Valve Repair Tests:

1.Take all measurements at ECU harness connector pins in order to check wire harness and traction control valve. Probe the connector carefully so that the terminals are not damaged.

2.Tractor Control Valve resistance measurements should read:

	Location	Measurement
	TCV to TCV Common	7 to 19 Ohms
	Release, Hold, Common	Open Circuit (no continuity)
	to Voltage or Ground
Cab-mount ECU:			Frame-mount ECU:
Looking into wire harness connector			Looking into wire harness connector

Connector	Pin	Traction Control Test
X1	4	Traction Control Valve Common
18 Way	5	Traction Control Valve

Connector	Pin	Traction Control Test
X3	7	Traction Control Valve
18 Way	13	Traction Control Valve Common

22