Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker(s). Be sure you have made a correct connection to the projector audio input. See "Connection" on page 18 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.Press Menu/Exit and then press / until the SYSTEM SETUP: Advanced menu is highlighted.
2.Press to highlight Audio Settings and press Mode/Enter. The Audio Settings page displays.
3.Highlight Mute and press / to select On.
Adjusting the sound level
To adjust the sound level, press Volume +/- on the remote control, or:
1. Repeat steps
2. Press to highlight Volume and press / to select a desired sound level.
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.Repeat steps
2.Press to highlight Power On/Off Ring Tone and press / to select Off.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound mute or changing the sound level will not affect the Power On/Off Ring Tone.
Personalizing the projector menu display
The
•Menu Display Time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in
•Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD position in five locations. Use / to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector
Operation 41