Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode. Go to http://lamp.BenQ.com for a replacement lamp.
The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 57 for details.
The following Lamp warning displays will remind you to change the lamp.
Status | Message | |
|
| |
The lamp has been in operation equivalent to | Notice | |
2500 hours. Install a new lamp for optimal | ||
| ||
performance. If the projector is normally run with | Order Replacement Lamp | |
Economic selected (see "Getting to know the lamp | ||
| ||
hour" on page 52), you may continue to operate | Lamp > 2500 Hours | |
the projector until the 2950 hour lamp warning | Order a new lamp at lamp.benq.com | |
appears. | ||
| ||
| OK | |
|
| |
The lamp has been in operation equivalent to | Notice | |
2950 hours. A new lamp should be fitted to avoid | ||
| ||
the inconvenience when the projector runs out of | Replace Lamp Soon | |
lamp time. |
| |
| Lamp > 2950 Hours | |
| Order a new lamp at lamp.benq.com | |
| OK | |
|
| |
The lamp has been in operation equivalent to | Notice | |
3000 hours. | Replace Lamp Now | |
| ||
It is strongly recommended that you replace the |
| |
lamp at this age. The lamp is a consumable item. | Lamp > 3000 Hours | |
The lamp brightness diminishes with use. This is | Lamp usage time exceeded | |
normal lamp behavior. You can replace the lamp | Order a new lamp at lamp.benq.com | |
whenever you notice that the brightness level has | OK | |
significantly diminished. If the lamp is not |
| |
replaced beforehand, it must be replaced after |
| |
3000 hours usage. |
| |
|
| |
The lamp MUST be replaced before the projector | Notice | |
will operate normally. | ||
| ||
| Out of Lamp Usage Time | |
| Replace lamp (refer to user manual) | |
| Then reset lamp timer | |
| Order a new lamp at lamp.benq.com | |
| OK | |
|
|
Maintenance 53