Manually corrects distorted images resulting from an angled projection.
7.Page Up and Down (Refer to "Remote paging operations" on page 26 for more information.)
You can operate your display software program (on a connected PC) which responds to page up/down commands (like Microsoft PowerPoint) by pressing these buttons.
8.Auto (Refer to
9.Source (Refer to "Switching input signal" on page 25 for more information.) Sequentially selects the input signal RGB, Component Video,
10.Blank (Refer to "Hiding the image" on page 25 for more information.)
Used to hide the screen image. Press any key on the remote control to restore the image.
11.Mode (Refer to "Application Mode" on page 29 for more information.)
Depending upon which input signal is selected, there are several picture setup options available.
Remote control effective range
~ 6 M
Make sure that there are no obstacles between the remote control and the IR sensors on the projector that might obstruct the
Replacing the remote control battery
1.Pull out the battery holder.
2.Insert the new battery in the holder. Note the positive polarity should face outward.
3. Push the holder into the remote control.
•Avoid excessive heat and humidity. There
may be battery damage if the battery is incorrectly replaced.
•Replace only with the same or equivalent type recommended by the battery manufacturer.
•Dispose of the used battery according to the manufacturer’s instructions.
•Never throw a battery into a fire. There may be danger of an explosion.
•If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent damage to the remote control from possible battery leakage.
10 Introduction
