BenQ MW811ST, MX812ST user manual Adjusting the projected image, Adjusting the projection angle

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 quick-release adjuster foot and 2 rear adjuster feet. These adjusters change the image height and projection angle. To adjust the projector:

1.Press the quick-release button and lift the

front of the projector. Once the image is positioned where you want it, release the quick-release button to lock the foot in

	position.
2.	Screw the rear adjuster feet to fine-tune the
	horizontal angle.	2	1	2
To retract the foot, hold up the projector while
pressing the quick-release button, then slowly			Do not look into the lens while
lower the projector. Screw the rear adjuster feet
			the lamp is on. The strong light
in a reverse direction.
			from the lamp may cause
If the projector is not placed on a flat surface or			damage to your eyes.
			Be careful when you press the
the screen and the projector are not
perpendicular to each other, the projected image			quick-release button as it is
becomes trapezoidal. To correct this situation,			close to the exhaust vent where

see "Correcting keystone" on page 25 for details. hot air comes from.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector or remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of Frequency and Clock to provide the best picture quality.

The current source information will be displayed in the corner of the screen for 3 seconds.

• The screen will be blank while AUTO is functioning.

•This function is only available when PC signal (analog RGB) is selected.

Fine-tuning the image clarity

Sharpen the image by rotating the focus ring.

24 Operation