BenQ MX880UST Timing of replacing the lamp, Install a new lamp for optimal performance. If the

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.

Go to http://lamp.benq.com for a replacement lamp.

The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 66 for details.

The following Lamp warning displays will remind you to change the lamp.

Status	Message
Install a new lamp for optimal performance. If the	Notice
projector is normally run with Economic selected
(See "Getting to know the lamp hour" on page 61),	Order Replacement Lamp
you may continue to operate the projector until
	Lamp>XXXX Hours
the next hour lamp warning appears.
Press ENTER to dismiss the message.	Order a new lamp at lamp.benq.com
	OK
It is strongly recommended that you replace the	Notice
lamp at this age. The lamp is a consumable item.
The lamp brightness diminishes with use. This is	Order Replacement Lamp
normal lamp behavior. You can replace the lamp
	Lamp>XXXX Hours
whenever you notice that the brightness level has
significantly diminished.	Order a new lamp at lamp.benq.com
Press ENTER to dismiss the message.	OK
The lamp MUST be replaced before the projector	WARNING
will operate normally.
	Out of Lamp Usage Time
Press ENTER to dismiss the message.
	Replace lamp (refer to User Manual)
	Then reset lamp timer
	Order a new lamp at lamp.benq.com
	OK

"XXXX" shown in the above messages are numbers that vary depending on different models.

62 Maintenance