Adjusting the image
Adjusting the height
Place your projector on a flat level surface and ensure that the projector is square to the screen.
The projector is equipped with 2
1.Lift the projector up and press the adjuster button to release the adjuster. The adjuster will drop into position and be locked.
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes or sight.
2.Screw the rear adjuster feet to
To retract the foot, press the adjuster button again.
If the screen and the projector are not perpendicular to each other, the projected image becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the Display menu, on the projector control panel or on the remote control.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press Auto on the control panel of the projector or on the remote control. Within 3 seconds, the
The screen will be blank while Auto is functioning.
Operation 21