1.Turn the power off and disconnect the projector from the wall
socket. Turn off all connected equipment and disconnect all other cables.
2. After it has cooled down, turn the projector over. Then loosen the screws and remove the lamp cover as indicated in the picture.
3.Move the latch to another end as shown in the picture.
4.Loosen the screw that holds the lamp to the projector. If the screw is not loosened completely, they could injure your fingers. It is
strongly recommended that you use a
5.Lift the handle so that it stands up. Use the handle to slowly pull the lamp out of the projector.
Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector. To reduce the risk of injuries to fingers and damage to internal components, use caution when removing lamp glass that has shattered.
Do not place the lamp in locations where water might splash on it, children can reach it, near or above heat sources, or near flammable materials.
Do not insert your hands into the projector after the lamp is removed. If you touch the optical components inside, it could cause color unevenness and distortion of the projected images.
6.Insert a new lamp. Make sure the handle is fully locked, move the
latch back, and tighten the screw firmly.
Loose screw may cause a bad connection, which could result in malfunction.
Do not over tighten the screw.
7.
8.Resetting the lamp counter
i.When the projector is next started, press and hold the Exit 5 button on the projector for 5 seconds to display the total used lamp time.
ii.Press Auto on the projector or on the remote control to reset the lamp hour to “0”.
iii.Wait about 5 seconds to let the OSD close.
Additional information | 23 |
