Controlling the projector through a Lan environment
Lan Control Settings allow you to manage the projector from a computer using a web browser when the computer and the projector are properly connected to the same local area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1.Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to the RJ45 port.
2.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
3.Press 
to highlight Lan Control Settings and press MODE/ENTER. The Lan Control Settings page displays.
4.Press 
to highlight Control By and press 
/ 
to select RJ45.
Network |
|
Network State | Disconnect |
DHCP | Off |
Projector IP Address | 0.0.0.0 |
Subnet Mask | 0.0.0.0 |
Default Gateway | 0.0.0.0 |
DNS | 0.0.0.0 |
Apply
Menu Back
5.Press 
to highlight DHCP and press 
/ 
to select On.
6.Press 
to highlight Apply and press MODE/ENTER.
7.
If the Projector IP Address still does not display, contact your ITS administrator.
English
Operation 43
