English
Personalizing the projector menu display
The
•Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 
/ 
to select a suitable time frame.
•Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD position in five locations. Use 
/ 
to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD menus. Use 
/ 
to select your language.
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector 
/ 
to select a screen.
Shutting down the projector
1. Press 
POWER and a confirmation message displays prompting you. If you don’t respond in a few seconds, the message will disappear.
If you want to cancel the message, press any key except PAGE 
/
and LASER on the remote control. Or you
can press 
POWER on the projector and a warning message appears. Press
POWER again.
2. Once the cooling process finishes, the POWER indicator light is a steady orange and fans stop.
3. Disconnect the power cord from the wall socket if the projector will not be used in an extended period of time.
•Do not look into the laser light window or shine the laser light beam on yourself or others. See the warning messages on the back of the remote control prior to using it.
•To protect the lamp, the projector will not respond to any commands during the cooling process.
•If the projector is not properly shut down, to protect the lamp, when you attempt to
•Lamp life results will vary depending on environmental conditions, and usage.
46 Operation
