BenQ VP150X B Lamp Replacement, Lamp is not well attached, Temperature is too high, Normal status

2.Lamp is not well attached

If the LED blinks rapidly, it indicates that the lamp is not attached properly.

3.Temperature is too high

If the internal temperature of the projector is too hot to operate safely, the LED will blink slowly for one minute and then the lamp will turn off automatically.

4.Normal status

If the LED light is off, it means the lamp and temperature inside the projector are normal.

Caution

The lamp indicator will light up when the lamp becomes too hot. Turn off the power and let the projector cool down for 45 minutes, then turn it on again. If the indicator is still on, contact your dealer.

B Lamp Replacement

When replacing the lamp, turn off the projector and unplug the AC cord. Wait for 45 minutes so that the lamp can be cool. High-pressure lamp may explode if improperly handled.

Caution

zDispose of used lamps in accordance with local authorities.

zDo not apply shocks to it or scratch it, as the lamp is made of glass.

zFurthermore, do not use an old lamp, because this could cause the lamp to explode.

zIf it the lamp has exploded, disconnect the power cord from the outlet and ask your dealer to replace the lamp. The lamp is covered by a front glass panel and an air-tight structure, but, in rare cases, the reflector and the inside of the projector may be damaged by scattered, broken pieces of glass, which could cause injury while being handled.

1.Switch the main power off and disconnect the power cord from the outlet.

2.Remove the lamp cover.

zIf hot, the lamp could cause burns. Wait for about 45 minutes until lamp cools down.

zLoose a screw and remove the cover.

3.Loose the screw and pull the handle to remove the lamp.

zIf the screw is not loosened completely, you could injure your fingers.

zDo not insert your hand into the box after the lamp is removed. (There are optical parts inside that could result in color unevenness, if touched.)

4.Replace a new lamp and secure it using the same screw.

zFirmly tighten the screws. Loose screws could result in poor connection, which will cause the unit to malfunction.

5.Install the lamp cover and secure it with a screw.

zTo prevent burns, install the lamp cover and secure it using the screw.

zDo not turn on power when lamp cover is removed.

zWhenever the lamp is replaced, reset the total operation time of the lamp. Do not reset if a new lamp is not replaced.

zDo not reset the timer without lamp replacement, as this can cause lamp breakage .

12English