|
|
|
| TROUBLESHOOTING GUIDE |
|
|
|
| |
OVEN PROBLEM |
|
| POSSIBLE CAUSES AND/OR REMEDY | |
Range does not function |
| Range is not connected to electrical power. Ask a professional to check | ||
|
|
|
| power circuit breaker, wiring and fuses. |
Self‐clean cycle does not activate | Door is not shut tight enough for automatic door latch to lock | |||
Broil does not work |
|
| Temperature control knob is rotated too far past broil position (500°F); | |
|
|
|
| PRE‐HEATING indicator will light intermittently |
Door does not open |
|
| Oven is still in self‐clean mode. Door latch will release when safe | |
|
|
|
| temperature is reached. |
Oven light does not work |
| Light bulb is burned out. Range is not connected to power/ clean is cycle | ||
|
|
|
| on |
Igniters does not work |
| Circuit is tripped. Fuse is blown. Range is not connected to power. | ||
Igniters sparking but no flame | Gas supply valve is in “OFF” position. Gas supply is interrupted. | |||
ignition |
|
|
|
|
Igniters spark continuously after | Ignition micro‐switches remain incorrectly engaged; call a qualified | |||
flame ignition |
|
| technician for repair. | |
Burner ignites but flame is large, | Burner ports are clogged. Unit is not set to the appropriate gas type. Call | |||
distorted, or yellow |
|
| a qualified technician for gas conversion procedure. | |
Oven door is locked and will not | Turn the oven off at the circuit breaker and wait 5 minutes. Turn breaker | |||
release, even after cooling |
| back on. The oven should reset itself and will be operable. | ||
|
|
|
| Check the circuit breaker or fuse box to your house. Make sure there is |
Oven is not heating |
|
| proper electrical power to the oven. Make sure the oven temperature | |
|
|
|
| has been selected. |
Oven light is not working | Replace or reinsert the light bulb if loose or defective. | |||
properly |
|
|
|
|
Oven light stays on |
|
| Check for obstruction in oven door. Check to see if hinge is bent. | |
Cannot remove lens cover on | There may be soil build‐up around the lens cover. Wipe lens cover area | |||
light |
|
|
| with a clean dry towel prior to attempting to remove the lens cover. |
PRE‐HEATING indicator lights up | This is a FAULT alarm indicating the failure of the cooling fan/s. Try | |||
intermittently and | sound | alarm | resetting by turning both selectors to the OFF position. If the error is not | |
on |
|
|
| repaired, call a qualified technician for diagnosis and repair. If not |
|
|
|
| repaired, this error indicator will appear again within 10 seconds once |
|
|
|
| the oven is activated in any functions for which cooling fans are required |
|
|
|
| to operate, preventing the use of the oven. Set both selectors to OFF |
|
|
|
| position and call a qualified technician for repair. |
HEATING | indicator | light turned | This is a FAULT indicating failure of the oven sensor temperature probe; | |
on intermittently and with sound | in this case cooling fans will start automatically. To reset, switch both | |||
alarm on |
|
|
| selector to the OFF position. To stop buzzer and light indicator, |
|
|
|
| disconnect the appliance from the main electrical supply and call a |
|
|
|
| qualified technician for repair. |
CLEAN | indicator | light | on | Electrical power failure happening during cleaning cycle operation; |
intermittently and | sound | alarm | cleaning cycle interrupted; cooling fans remains both activated; the | |
on |
|
|
| error will be reset by putting two selectors in OFF position; repeat |
|
|
|
| cleaning cycle if needed after 3‐4 hours. |
|
|
|
| 37 |