Best U102E manual Wiring, Blower connection at hood, Exterior or In-line blower connection

WIRING

! CAUTION: All electrical wiring should be done by a qualified person (s) in accordance with all applicable codes and standards. This range hood must be properly grounded.

Do not turn power on at service panel until all wires have been connected.

Blower connection at hood:

1.Run 2-wire plus ground power cable from the Exterior or In-Line Blower to the hood’s wiring box marked “motor connection”.

2.Remove the cover from the wiring box and remove one knockout.

3.Secure the conduit to the wiring box through a conduit connector.

4.Make electrical connections at the hood. Connect white-to-white, red-to-blackand green-to-ground.

5.Replace the wiring box cover and screws. make sure wires are not pinched between the cover and box.

Exterior or In-line blower connection:

1.Make electrical connections at the exterior or in-line blower (see instructions provided with the exterior or in-line blower).

Power connection at hood:

1.Run 120 VAC electrical power cable to the hood wiring box marked “120VAC input”.

2.Remove the cover from the wiring box and remove one knockout.

3.Secure the conduit to the wiring box through a conduit connector.

4.Make electrical connections at the hood. Connect white-to-white, black-to-blackand green-to-ground.

5.Replace the wiring box cover and screws. Make sure wires are not pinched between the cover and box.

BLOWER CONNECTION AT

HOOD

Exterior or

In-Line blower

BOX MARKED

“MOTOR

CONNECTION”

CONNECT: WHITE-TO-WHITE,

RED-TO-BLACK,

GREEN-TO-GROUND.

POWER CONNECTION AT HOOD

120 Volt 60Hz

LINE-IN

CONNECT: WHITE-TO-WHITE, BLACK-TO-BLACK,

GREEN-TO-GROUND. BOX MARKED “120 VAC INPUT”

- 12 -