Best UP27E, UP271 Install The Hood, Reinstall The Pan, Do not plug the two cords into each other

10.INSTALL THE HOOD

Place the hood at its location. Using a pen, mark the position of the screw (smaller part of the keyholes [A]). Remove the hood and install (4) 1/2” double thread screws at marked positions, leaving a 1/8” gap.

Place the hood under the cabinet and slide it in position. Make sure the adapter/damper enters the ducting and the damper opens freely (UP27I Series range hood only), or ensure ducting connects to rough-in plate (UP27E Series range hood only). Secure the hood by tightening the screws completely. Install the last 1/2” double thread screws in the remaining holes [B].

UP27I HOOD RETAINING SCREWS LOCATION	UP27E HOOD RETAINING SCREWS LOCATION
	A
	B
	A
	B
HD0213

11.INSTALL THE BLOWER (EXTERIOR BLOWER, UP27E SERIES RANGE HOOD ONLY)

Refer to instructions included with blower.

Once the blower is installed, plug the blower cord (A) into the female receptacle and the power supply cord (B) onto the male connector inside the hood.

!WARNING

Do not plug the two cords into each other.

AB

HE0078

12.REINSTALL THE PAN

Using a Phillips screwdriver and the pan retaining screws, reinstall the pan (previously removed in step 6) inside the hood (shaded parts on illustration below).

UP27I RETAINING SCREWS LOCATION			UP27E RETAINING SCREWS LOCATION
A	A	A A	A	A	A	A
B	B
	B
A: no. 8 x 3/8”		B: no. 6 x 1/2”		A: no. 8 x 3/8”
HD0207
		- 11 -