8.PREPARE THE HOOD (CONT’D)
8.1UP27I SERIES RANGE HOOD (INTERNAL BLOWER) (CONT’D)
HORIZONTAL DISCHARGE (DUCTED INSTALLATION ONLY)(CONT’D)
Using 3 no. 8 x 3/8” screws provided with hood, secure the adapter/damper on the back of the hood. Remove tape from damper flap.
TOP OF HOOD |
|
ADAPTER/DAMPER |
|
SCREW LOCATION | BACK OF HOOD |
| |
HD0204 |
|
Seal the adapter/damper and the metal
8.2UP27E SERIES RANGE HOOD (EXTERIOR OR IN-LINE BLOWER)
Run house wiring (120 V AC) to installation location. Refer to the instructions included with the selected
HD0205 |
WIRING COVER |
ON TOP OF HOOD |
LOCKNUTS |
HD0210 |
9. CONNECT WIRING
!WARNING
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting means to prevent power to be switched on accidentally.
9.1UP27I SERIES RANGE HOOD (INTERNAL BLOWER)
Run house wiring (120 V AC) to installation location. Place the electrical cable clamp, insert the cable in the hood and tighten the electrical cable clamp to secure the cable. Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw.
9.2UP27E SERIES RANGE HOOD (EXTERIOR OR
Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. Reinstall wiring cover on
- 10 -