Beyonwiz DP-S1 manual Quick Setup, Service Scan

Quick Setup

2-3. Service Scan

Before watching a broadcasted program, you need to scan all the services first. The scanned services will be stored in the non-volatilize memory. Therefore you don’t have to scan the service again unless you delete all the information of the service stored in the memory. If there are no services scanned previously, the service scan page will be presented automatically.

You can select the options for each item with a pop-up menu. Please press the OK button to get a pop-up menu.

zAntenna DC (+5V) Power: You can supply DC (+5V, max. 100mA) power to the indoor antenna through the antenna cable. Please make sure that your external antenna is an active type, which means that the antenna requires external DC power to enhance the sensitivity, before you supply DC power to the antenna.

zScanning Range: You can scan over all channels (VHF and UHF) by selecting the “FULL” option. If you want to scan over specific channel(s), please select the “PARTIAL” option. In this case, you have to set the start and end channels manually.

zStart Channel: This menu will be enabled when you choose the “PARTIAL” option. Please press the OK button to select the start channel.

zEnd Channel: This menu will also be enabled when you choose the “PARTIAL” option. The end channel must be greater than the start channel.

zSignal Quality Bar: Two horizontal bars indicate the signal quality of the start and end channels. The leftmost rectangular changes from black to yellow if the tuner locks the signal properly.

DANGER

zIF THE ANTENNA IS PASSIVE TYPE, THE DC POWER WILL DAMAGE THE ANTENNA AND THE DP-S1 ITSELF.

27