Billy Goat VQ1002SP, VQ802SPH specifications Handling & Transporting, Storage, OPERATION continued

16OPERATION continued

16.4HANDLING & TRANSPORTING:

Do not lift by hand. Use loading ramps or other mechanical assis- tance. Secure in place during transport.

16.5STORAGE

Never store engine indoors or in enclosed poorly venti- lated areas with fuel in tank, where fuel fumes may reach an open flame, spark or pilot light, as on a furnace, water heater, clothes dryer or other gas appliance.

If engine is to be unused for 30 days or more, prepare as follows:

Be sure engine is cool. Do not smoke. Remove all gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and causing possible malfunction of engine. Drain fuel outdoors, into an approved container, away from open flame. Run engine until fuel tank is empty and engine runs out of gasoline.

NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow mix ratio found on stabilizer container. Run engine at least 10 min. after adding stabilizer to allow it to reach the carburetor.

See 16.3 DEBRIS BAG on page 6.

Rear Wheels - Turf Tread 13" Dia. x 6.5" (330 mm x 165 mm) wide pnuematic.

Casters - 8" (203 mm) Dia. semi-pnuematic tires with ball bearing swivel.

Curb Guide

Rollers.

Part No. 830542 Page 13 of 16

Diverter rod must be in this position for normal pickup.

33" (838 mm) wide nozzle.

2" Front Guide Wheels adjust nozzle height to keep it raised just above cleaning surface.

Form No. F021302G