Maintenance and care (continued)
Empty dirt container
3.
The dirt container needs to be emptied when the dirt reaches the “Full” line on the container.
1.Unplug the vacuum from electrical outlet.
2. Slide the Lock ‘n Seal Lever to the “Unlock”
position.Unlock
3. Grasp handle and pull the dirt container | 4. | |
straight out to remove from the vacuum. | ||
|
4. Empty dirt into garbage container.
NOTE: Emptying the dirt container after every use will help prevent over filling and ensure that the vacuum is ready to go the next time you clean.
Cleaning the pre-motor and post-motor HEPA media filter
1. Unplug the vacuum from electrical outlet. | ||
2. The | HEPA | |
Media | ||
from dirt particles. It is located in the | Filter | |
slide out tray underneath the dirt |
| |
container. If the filter becomes dirty, pull |
| |
out the tray, lift out the foam filter pad |
| |
and clean it. | Washable | |
NOTE: The | ||
hand washed in cold water with mild Filter | ||
detergent. Rinse well and air dry |
| |
thoroughly before replacing. |
| |
3. The |
| |
assists in the filtration process to |
| |
return clean air to the room. It is |
| |
located behind the door on the side |
| |
of the vacuum. If the filter becomes | WARNING: | |
dirty, open the door, remove the filter | ||
and replace. | Do not operate cleaner | |
NOTE: The | with damp or wet filters or | |
white, pleated HEPA media filter. This | without all filters in place. | |
filter is not washable and must be |
| |
replaced when it becomes dirty. |
|
12 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
8/18/06 4:49:27 PM