Assembling your vacuum
The only tool you’ll need to assemble your vacuum cleaner is a Phillips screwdriver.
Attach handle to vacuum
1. Locate the handle and cord wrap. Remove the screw packet taped to the cord wrap.
2.Stand the vacuum upright and from the rear of the unit, slide the base of the handle firmly into the grooves at the top of the vacuum body.
3.IMPORTANT – before inserting the screws into the handle, slide the cord wrap into the handle.
4.Ensure that the handle and cord wrap are firmly fit to the vacuum body. If there are any gaps, continue to push firmly until the handle and cord wrap are flush.
5.Insert 2 of the screws provided (3 total) into the existing holes, attaching the cord wrap and handle to the body of the vacuum. Tighten securely with a screwdriver.
6.Attach the hose and cord clip by snapping it into the handle of the unit. Secure it by inserting the screw provided.
7.Attach the lower hose clip by snapping it into place and twisting to the right.
Attach vacuum hose and tools
1.Line up the tabs on the base of the Twist ‘n Snap hose with the corresponding notches on the hose collar as shown.
2.Turn the Twist ‘n Snap hose to the left to lock the hose into place.
3.Connect the curved hose wand to the hose. Grasping the curved hose wand, slide the end of the curved hose wand onto the hose wand base. Snap the hose into the hose clip.
NOTE: The vacuum will not operate effectively unless the curved hose wand is firmly attached.
CAUTION:
Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.
2.
3.
7.
6.
Hose Clip 
WARNING:
Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
1.
Twist 'n
Snap Hose
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 5 |
8/18/06 | 4:49:22 PM |
