Operations
Portable spot cleaning mode continued
Cleaning with Deep Reach™ Tool |
| |
1. | Set tool on soiled surfaces and press the | 1. |
| trigger to spray solution onto the soiled |
|
| area to be cleaned. |
|
2. | Slowly move the tool back and forth |
|
| over the soiled surface, keeping the tool |
|
| in contact with the carpet. | 3. |
| Release trigger and move tool slowly | |
|
| |
| over the soiled area to suction up |
|
| water and dirt. |
|
4. | Continue to clean the area, working |
|
| in small sections, until no more dirt |
|
| can be removed. |
|
Empty dirty tank
Follow the instructions under Empty dirty tank section on page 9 of the Upright cleaning mode section.
Replacing portable machine on base
1.Align the product with the cord side on the left and hose side on the right.
2.Push down the portable spot cleaner until both sides click securely into place. Test the fit by pulling up on the carry handle to make sure it is secure. To further check if the portable spot cleaner is secure, plug in and turn on to verify that the heat indicator light is illuminat- ed. If the heat indicator light does not illuminate, release the pod and
1.
Cord | Hose | |
side | ||
side | ||
|
Cleaning portable machine
1.Remove and rinse the tools in clean, running water. Dry and replace in the tool storage provided.
2.It is recommended that you suction clean water from a bowl to rinse out the hose. Then lift end of hose and stretch out to ensure all water is cleared from hose.
3.Coil flex hose around the hose wrap and secure with latch.
4.Check suction gate and if it appears dirty, follow steps
12
