Maintenance and care
Cleaning the pre-motor filter
The
1.Unplug the vacuum from electrical outlet.
2.Disconnect hose
3.Open the dust bag compartment by lifting up on the latch on the door at the front of the vacuum. Lift out the dust bag holder and dust bag.
4.Remove the filter frame from the filter holder by grasping the lip of the frame and pulling up.
5.Remove the filter from the filter frame and clean by hand washing in warm water. A mild detergent can be used if desired. Allow the filter to air dry thoroughly before replacing.
6.Place the filter back into the filter frame and replace back into the filter holder.
NOTE: The filter frame should be placed so the protective frame is visible.
7.Place dust bag holder and dust bag into the dust bag compartment, mak- ing sure the entire bag is tucked in below the seal gasket.
8.Close dust bag compartment door and press down gently until it locks into place.
9.Reconnect hose.
NOTICE:
This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.
Washable Pre-
Motor Filter
3.
Tip:
For maximum cleaning perfor- mance, check the filters often and clean or replace if necessary.
WARNING:
Do not operate cleaner with damp or wet filters or without all filters in place.
11
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
