Troubleshooting
Vacuum cleaner won’t run
Possible causes
1.Vacuum cleaner is not plugged in
2.Power button is not pressed down
WARNING:
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing mainte- nance or troubleshooting.
Remedies
1.Check electrical plug
2.Press power button down
Vacuum cleaner won’t pick up or low suction
Possible causes
1.Tools, flex hose and/or telescoping extension wand are blocked
2.Filters are dirty
3.Dust bag is full
4.Swivel hose not securely attached to suction opening
5.Crack or hole in flex hose
6.Air flow regulator or variable suction power control is set to open or minimum setting
Remedies
1.Remove each part and check for blockages
2.Check and clean or replace
3.Replace with new dust bag
4.Make sure swivel hose is locked into suction opening
5.Check hose and replace if needed
6.Change to closed or maximum setting
Visible dust escaping from vacuum
Possible causes | Remedies | |
1. | Dust bag is full | 1. Replace with new dust bag |
2. | Filters missing or installed incorrectly | 2. Check |
|
| correct installation |
3. | Filters are dirty | 3. Check and clean or replace |
|
| and |
4. | Flex hose is blocked | 4. Remove hose and check for |
|
| blockages |
5.Swivel hose not securely attached to suction opening
5.Make sure swivel hose is locked into suction opening
6. Crack or hole in flex hose | 6. Check hose and replace if needed |
15
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
