Model # 900149: Page 6
Initial Set Up
Do NOT plug in until steps 1-3 are completed.
1.Allow unit to sit upright for 4 hours.
2.Set probe length (see illustration 1):
"If using a 5 gallon round bottle, use the probe as it is supplied.
"If using a 5 gallon rectangular bottle, remove section C. Save for future use.
"If using a 3 gallon bottle, remove sections C & B. Save for future use.
3.Install bottle:
"Open door and place fresh bottle in front of tray.
"Clean fresh bottle with a soft cloth and warm soapy water then rinse.
"Remove entire plastic cap from top of bottle.
"Insert probe into bottle.
"Push down on probe until it is seated.
"Create a seal by turning handle clockwise until tight – do NOT over tighten.
"Slide bottle onto tray and close door completely.
NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in illustration 2.