AS202Pub1000003006 5/18/06 3:34 PM Page 2

IMPORTANT SAFETY

INSTRUCTIONS

When using your iron, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING.

Use iron only for its intended use.

To protect against a risk of electric shock, do not immerse the iron in water or other liquid.

The iron should always be turned off (refer to "How to Use" section) before plugging into or unplugging from an outlet. Never yank cord to disconnect from outlet; instead grasp plug and pull to disconnect.

Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around cord wrap when storing.

Always disconnect iron from electrical outlet when filling with or emptying of water, and when not in use.

Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, take it to a qualified serviceman for examination and repair. Or, call the appropriate toll-free number listed on the cover of this manual. Incorrect reassembly can cause a risk of electric shock when the iron is used.

Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board.

Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down or use the surge of steam — there may be hot water in the water tank. Avoid rapid movement of iron to minimize hot water spillage.

SPECIAL INSTRUCTIONS

To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.

If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS.

IMPORTANT DOWNY WRINKLE RELEASER® LIQUID INSTRUCTIONS

1.The physiological effects of the operation of the Downy Wrinkle Releaser® liquid, beneficial or otherwise, have not been investigated by Underwriters Laboratories Inc.

2.First aid measures –

a.Eye Contact: Immediately flush eyes with plenty of water for at least

15 minutes. If irritation occurs or persists, have eyes examined or treated by medical personnel.

b.Skin Contact: Remove contaminated clothing and footwear. Wash material off skin with plenty of soap and water. Wash clothing and footwear before reuse.

c.Ingestion: Drink milk or water to dilute. Induce vomiting only if advised by physician or poison control center. Contact physician or poison control center.

3.Personal precaution –

a.Avoid prolonged exposure.

b.Use rubber or neoprene, when needed, to prevent skin contact.

c.Use safety glasses recommended for handling spills.

4.Care and storage – Store in a cool, dry place. In poorly ventilated areas, solvent fumes may be irritating. Masks rated for ammonia or organic solvents may be desirable. Make sure you have good ventilation when handling liquid spills.

5.Disposal Considerations – Disposal of this Downy Wrinkle Releaser® liquid must be in accordance with local, state and federal regulations.

Soft-Touch Parts

Note: The soft-touch parts of this unit are free of natural rubber and latex. They are safe for individuals allergic or sensitive to these materials.

POLARIZED PLUG (120V Models Only)

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit into a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.

TAMPER-RESISTANT SCREW

Warning: This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electric shock, do not attempt to remove the outer cover. There are no user-serviceable parts inside. Repair should be done only by authorized service personnel.

Note: If the power supply cord is damaged, it should be replaced by qualified personnel or in Latin America by an authorized service center.

1

2

Page 2
Image 2
Black & Decker AS202 Important Safety Instructions, Special Instructions, Soft-Touch Parts Polarized Plug 120V Models Only