7.Secure the blade holder (P) into the required jug by pushing it into the jug and turning it clockwise.
8.For the mincer, fit the mincer blade (L) into mincer jug (K).
9.Fit the mincer lid (M) and secure it by turning it clockwise.
10.Fit the blender jug (C), grinder jug (N) or mincer jug (K) to the blender body (I) by turning it clockwise.
Use
1.Place the appliance on a flat, stable surface.
2.Put the ingredients into the required jug (C, K or N).
3.If using the blender push the lid (B) and filler cap (A) onto the jug (C). The filler cap and lid are secured by turning them clockwise.
4.If using the grinder or mincer seal the jug by
fitting the required blade holder (P or M) and secure by turning clockwise.
5.Place the jug (C, N or K) onto the blender body (I).
6.Secure the jug (C, K or N) by turning it anti clockwise.
7.Connect it to the electrical supply and select the required speed using the rotary switch.
The following settings are available:-
P = Pulse Operation O = Power Off
1 = Low Speed
2 = Low to medium speed
3 = Medium speed
4 = Medium to high speed
5 = High Speed
The appliance should be disconnected from the mains supply before removing the jug.
ENGLISH
Recommendations when blending
Ingredients | Max Run Time | Speed | Max Quantity |
| (Seconds) |
| (ml) |
|
|
|
|
Liquids | 60 sec | 3 to 5 | 1.25L |
|
|
|
|
Semi |
|
|
|
Liquids | 30 sec | 1 to 3 | 0.75 to 1.5L |
|
|
|
|
*Semi Liquids assumes maximum of 250 grams of fruits, vegetables or ice in 2.5x2.5 cm cubes along with 500 ml of water or any other liquid of similar consistency.
Note: The blender should not be run for longer than 3 minute. After a continuous run of 3 minutes, the blender should be allowed to cool down for at least 10 minutes before further use.
Recommendations when grinding
Ingredients | Max Run Time | Speed | Max Quantity | |
| (Seconds) |
| (g) | |
|
|
|
| |
Dry Pepper/ | 20 sec | 2 | 60g | |
Coffee beans | ||||
|
|
| ||
Dry Pulses | 30 sec | 1 | 50g | |
Dry Herbs | 20 sec | 1 | 50g | |
|
|
|
|
Note: The dry grinder should not be run for longer than 1 minute. After a continuous run of 1 minute, the blender should be allowed to cool down for at least 10 minutes before further use.
Warning! The grinder should NOT be used for wet grinding of hard food materials like pulses, beans, grains etc. This will lead to damage of blades and reduction of motor life span.
5