Black & Decker BX560 Inspection and repairs, Electrical safety, Mains plug replacement, Assembly

ENGLISH

Inspection and repairs

•Switch off the appliance before cleaning, changing accessories or approaching parts which move in use

•Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.

•Do not use the appliance if any part is damaged or defective.

•Do not use the appliance if the blade is damaged.

•Have any damaged or defective parts repaired or replaced by an authorised repair agent.

•Before use, check the power supply cord for signs of damage, ageing and wear.

•Do not use the appliance if the power supply cord or mains plug is damaged or defective.

•If the power supply cord or mains plug is damaged or defective it must be repaired by an authorised repair agent in order to avoid a hazard. Do not cut the power supply cord and do not attempt to repair it yourself.

•Never attempt to remove or replace any parts other than those specified in this manual.

Electrical safety

Before use, check that the mains voltage corresponds to the voltage on the rating plate.

This appliance is double insulated in accordance with EN 60335-2-14; therefore no earth wire is required.

•To avoid the risk of electric shock, do not immerse the cord, plug or motor unit in water or other liquid.

•Check that the supply voltage shown on the rating plate of the appliance matches that of your electrical system. Any connection error will invalidate the guarantee.

Mains plug replacement

If a new mains plug needs to be fitted:

•Safely dispose of the old plug

•Connect the brown lead to the live terminal of the new plug

•Connect the blue lead to the neutral terminal

•If the product is class I (earthed), connect the green/yellow lead to the earth terminal

Warning! If your product is class II double insulated (only 2 wires in the cord set), no connection is to be made to the earth terminal

•Follow the fitting instructions supplied with good quality plugs

•Any replacement fuse must be of the same rating as the original fuse supplied with the product

Assembly

1.Wash all detachable parts (see chapter ‘Maintenance and cleaning’).

2.For the blender, fit the seal (E) on to the blade holder (G).

3.Place the blade holder (G) into the jug base

(D)and secure buy turning anti-clockwise.

4.Place the filler (A) cap into the lid (B) and secure by turning it clockwise.

5.Place the lid (B) on to the jug (C) and secure it by turning clockwise.

6.For the grinder, fit the jug seal (Q) into the groove around the edge of the grinder jug

4