
900Ub Upright Assembly Drawing
6
900Ub.Sr OM.R1.indd
900Ub Upright Assembly Instructions
Step 1: Stabilizer Bars Assembly
1. Place rear stabilizer bar under rear main frame body and align screw holes.
2. Insert two M8 x 90mm bolts into the stabilizer bar all the way through and into the holes on the frame
3. Secure rear stabilizer bar using an M8 nut and a curved washer on each bolt.
4. Repeat steps 1 – 3 to attach front stabilizer bar.
Step 2: Pedal Assembly
1. Use a 15mm
or L) on the top & bottom of each pedal. NOTE: Left pedal threads counterclockwise.
3. Retighten cranks after approximately 10 hours of use.
Step 3: Seat Post and Saddle assembly
1. Loosen the seat pin by turning it
2. Assemble saddle onto seatpost.
3. Tighten the affi xing nut and washer using a 17mm
Step 4: Console Mast Assembly
1.Remove the console mast plastic cover from the unit's body
by
2. Install console mast cover onto console mast.
3. Connect the main wire harness in the main frame to the main wire harness in the bottom of the console mast, taking care to install correctly. (See plug alignment marks)
4. Install the console mast by sliding it into the console mast receptor while gently pulling the wiring harness. This will keep the slack out of the harness so the wires will not get pinched and short out. Insert and tighten three M8 x 16mm bolts, one fl at washer on each side and a curve washer on the front using a 6mm Allen wrench. Be sure not to pinch wire harness while tightening these three screws and make sure that the two top holes are lined up with the holes on the receptor.
7
6/11/2008 9:56:03 AM