Siemens 420 manual Factory setting, Parameter Function

Issue 07/04 3 Functions

3.4Factory setting

The MICROMASTER drive unit is shipped from the plant with a Status Display Panel (SDP, refer to Fig.

3-12). The SDP has two LEDs on the front panel which display the operating state of the drive inverter (refer to Section 4.1).

When MICROMASTER is shipped from the plant with the SDP functioning, it can be operated without any additional parameterization. In this case, the drive inverter default settings (which depend on the drive inverter type / size) match the following data of a 4-

pole motor:	Fig. 3-12	Status Display
Rated motor power	P0307	Panel (SDP)
Rated motor voltage	P0304
Rated motor current	P0305
Rated motor frequency	P0310

(We recommend a Siemens standard motor.) Further, the following conditions must be fulfilled:

Control (ON/OFF command) via digital inputs	(refer to Table 3-7)
Setpoint input via analog input 1	P1000	= 2
Induction motor	P0300	= 1
Self-cooled motor	P0335	= 0
Motor overload factor	P0640	= 150 %
Min. frequency	P1080	= 0 Hz
Max. frequency	P1082	= 50 Hz
Ramp-up time	P1120	= 10 s
Ramp-down time	P1121	= 10 s
Linear V/f characteristic	P1300	= 0

Table 3-7	Pre-assignment of the digital inputs
Digital inputs		Terminals	Parameter		Function	Active
Command source		-	P0700 = 2		Terminal strip	Yes
Digital input 1		5	P0701 = 1		ON / OFF1	Yes
Digital input 2		6	P0702	= 12	Reversing	Yes
Digital input 3		7	P0703	= 9	Fault acknowledge	Yes
Digital input 4		Via ADC	P0704	= 0	Digital input disabled	No

MICROMASTER 420	Operating Instructions
6SE6400-5AA00-0BP0	57