Siemens 420 manual 10 JOG, JOG counter-clockwise and JOG clockwise

3 Functions Issue 07/04

3.10JOG

Parameter range:	P1055 – P1061
Warnings	A0923
Faults	-
Function chart number:	FP5000

The JOG function is used as follows:

To check the functionality of the motor and drive inverter after commissioning has been completed (the first traversing motion, checking the direction of rotation, etc.)

Positioning a drive / a driven load into a specific position Traversing a drive, e.g. after a program has been interrupted

The drive is traversed using this function by entering fixed frequencies P1058, P1059. The JOG mode can be selected either using the operator panel (refer to Section 3.1.3), digital inputs or also via the serial interfaces (refer to the example). An ON/OFF command is not used to move the drive, but when the "JOG keys" are pressed. These "JOG keys" are selected using the BICO parameters P1055 and P1056.

						A0923	A0923
		"1"
DIN	JOG right						t
	P1055	"0"
BOP		(0)
USS		"1"
	JOG left
BOP link							t
	P1056	"0"
USS
		(0)	f
COM link		P1082
CB
		P1058
COM link
							t
		P1059	P1060	P1061	P1060	P1061
		-P1082

Fig. 3-35 JOG counter-clockwise and JOG clockwise

MICROMASTER 420	Operating Instructions
104	6SE6400-5AA00-0BP0