Black & Decker CM1836R, CM 1836 instruction manual Maintenance, Mulching Mowing Tips

Models: CM1836R CM 1836

1 48
Download 48 pages 40.28 Kb
Page 11
Image 11
MOWING TIPS

4.

Position the grass catcher hanger hooks K-4on the mower as shown

K

 

 

in figure K. Release the rear discharge door.

 

 

 

DANGER: Sharp moving blade. Never operate the mower unless

 

4

the hanger hooks on the grass catcher are seated properly on the mower

 

 

and the rear discharge door rests firmly against the top of the grass

 

 

 

catcher as serious injury could result.

 

 

 

MOWING TIPS

 

 

 

NOTE: ALWAYSINSPECT AREA WHERE MOWER IS TO BE USED

 

 

 

AND REMOVE ALL STONES, STICKS, WIRE, BONES AND OTHER

 

 

 

DEBRIS WHICH MIGHT BE THROWN BY THE ROTATING BLADE.

 

 

 

1.

Mow across the face of slopes, never up-and-down. Exercise extreme

 

 

 

caution when changing direction on slopes. Do not mow excessively

 

 

2

2.

steep slopes. Always maintain good footing.

 

 

Release bail handle to turn mower “OFF” when crossing any gravel

 

 

 

3.

area (stones can be thrown by the blade).

 

 

 

Set mower at highest cutting height when mowing in rough ground or

 

 

 

in tall weeds. Removing too much grass at one time can cause the

 

 

 

4.

motor to be overloaded and to stop. Refer to troubleshooting guide.

 

 

 

If a grass catcher is used during the fast growing season, the grass may tend to clog up at the discharge opening. Release bail handle to turn

 

mower off and remove the safety key. Remove the catcher and shake the grass down to the back end of the bag. Also clean out any grass or

5.

debris which may be packed around the discharge opening. Replace the grass catcher.

 

If mower should start to vibrate abnormally, release bail handle to turn mower off and remove safety key. Check immediately for cause.

6.

Vibration is a warning of trouble. Do not operate mower until a service check has been made. Refer to troubleshooting guide in manual.

ALWAYSRELEASE BAIL HANDLE TO TURN MOWER OFF AND REMOVE SAFETY KEY WHEN LEAVING IT UNATTENDED EVEN FOR

 

A SHORT PERIOD OF TIME.

 

 

 

THE FOLLOWING SUGGESTIONS WILL HELP YOU TO OBTAIN OPTIMUM RUN TIME FROM YOUR CORDLESS MOWER:

1.

Slow down in areas where the grass is especially long or thick.

 

 

 

2.

When mulching, avoid cutting more than 1-1/2 inches (38mm) off the length at any one time.

 

3.

Avoid mowing when the grass is wet from rain or dew-soaked.

 

 

 

4.

Cut your lawn frequently, especially during high growth periods.

 

 

 

NOTE: IT IS RECOMMENDED THAT YOUR MOWER BE RECHARGED AFTER USE TO PROLONG THE BATTERY LIFE. FREQUENT

CHARGING WILL NOT HARM YOUR BATTERY, AND WILL ENSURE THAT THE BATTERY IS FULLYCHARGED AND READY FOR ITS

NEXT USE. STORING MOWER NOT FULLY CHARGED WILL SHORTEN BATTERY LIFE.

 

MULCHING MOWING TIPS

 

 

 

Your mower was shipped from Black & Decker with the mulch insert installed. While mulching, your new mower is designed to cut the grass clip-

pings into small pieces and distribute them back into the lawn. Under normal conditions, the mulched grass will biodegrade quickly to provide

nutrients to the lawn.

 

 

 

Please review the following recommendations for optimum mulching performance.

 

1.

Avoid mowing when the grass is wet from rain or dew. Wet grass may form clumps which interfere with the mulching action and reduce run-

2.

time. The best time to mow grass is in the late afternoon when the grass is dry and the newly cut area will not be exposed to direct sunlight.

For best mulching performance, set the cutting height to remove about one third of the grass blade

1

 

length, ideally no more than 1-1/2 in. (38mm) at one time. If the lawn is overgrown, it may be nec-

 

essary to increase the cut height to reduce the pushing effort and prevent overloading the motor.

3

 

For extremely heavy mulching, it is advisable to first cut at a high cut height setting, and then re-

 

 

cut to the final cut height. Otherwise, make narrower cuts and mow slowly. ALWAYS MAKE SURE

 

3.

BLADE IS SHARP.

 

 

 

For best performance, keep the mower housing free of built-up grass. From time to time release

 

 

bail handle to turn mower off and wait for the blade to come to a complete stop. Then remove the

 

 

safety key and turn mower on its side. Using an object such as a stick, wipe out any accumulation

 

 

of grass in the blade area. Be careful of the sharp edges of the blade. Clean often in wet, spring

 

4.

grass, and always after every use.

 

 

 

Certain types of g rass or grass conditions may require that an area be mulched a second time to fully disperse the grass throughout the lawn.

 

If cutting a second time, it is advisable to cut perpendicular (across) the first cut pattern. DO NOT CHANGE CUT PATTERN IN ANY WAY

5.

THAT WOULD CAUSE MOWING DOWN A HILL.

 

 

 

Change your cutting pattern from week to week. This will help prevent matting of the lawn.

 

MAINTENANCE

 

 

 

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement)

should be performed by BLACK & DECKER Service Centers or other qualified service organizations, always using Black & Decker replacement

parts. When servicing use ONLY IDENTICAL REPLACEMENT PARTS.

11

 

 

Page 11
Image 11
Black & Decker CM1836R, CM 1836 instruction manual Maintenance, Mulching Mowing Tips