Rotating the Rear Handle, Attachments

399080-02 rev 11/15/02 10:13 AM Page 8

English

CAUTION: Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other acces- sories running over rated speed can fly apart and cause injury.

ATTACHMENTS

Attachments designed specifically for this grinder can be purchased through DEWALT dealers and DEWALT Factory Service centers.

D284939	9" Type 27 guard
D284948	9" Type 28 guard
D284937	7" Type 27 guard
D284936	6" Type 11 Flaring cup guard with flange
D284934	4" Type 11 Flaring cup guard with flange
D284933	Type 11 flaring cup wheel backing flange
D284932	Type 1 Flange set
D284931	7" Type 1 Guard
054339-00	Grinding backing flange
22191-00	Clamp nut
61820-01	Wheel Wrench
445928-01	Soft mount spindle protector
397711-00	Rubber gear case bumper

ASSEMBLY AND ADJUSTMENTS Attaching the Side Handle

To install the side handle, thread the handle into one of the five positions listed below and tighten securely by turning clockwise.

•Two front positions: Forward handle positions are designed for optimized balance in surface finishing applications.

• Two rear positions: Rear handle positions are designed for optimized balance in edge grinding applications.

•One top position: Top handle position is

designed for edge grinding applications.

NOTE: D28497 includes only three handle positions.

Rotating the Rear Handle

Turn off and unplug tool before making any adjustments or removing or installing accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.

1. Unlock the rear handle by pulling out the Handle Re- lease Lever (G) as shown.

2. Rotate handle into available 0°, 30°, 60°, or 90° position left OR right of center.

3. Push in the handle release	G
lever.

4.Before turning the tool on, ensure that the handle is locked into a position and the handle release lever has returned to the orig- inal position flush with the tool housing.

Rotating the Gear Case