Black & Decker FP1610 manual How to Use, Control Panel, Controls, Slicing/Shredding Discs

FP1610SPub600021 3/31/05 2:14 PM Page 4

Product may vary slightly from what is illustrated.

† 1.	Food pusher (Part # MP12-3-102 )	8.	Base
† 2.	Food chute/cover	† 9.	Dough blade
	(Part # MP12-2-600)		(Part # MP12-3-017)
† 3.	Slice/Shred disc (Part # MP12-2-500)	†10. Chopping blade (Part # MP12-3-400)
† 4.	Disc stem (Part # 210204-100)	†11. Extra-thin slice/Fine shred disc
† 5.	10-cup (2365 ml) container		(Part # 211704-100 )
	(Part # MP12-2-200)	†12. Storage lid (Part # 211801-002)
6.	Center post	†Consumer replaceable
7.	Control panel

CONTROL PANEL

1. OFF/Pulse control

2. High and Low speed controls

3. Power indicator light

How to Use

This product is for household use only.

•Before first use, unpack the product and remove packing material. Handle sharp chopping blade and slice/shred discs carefully.

•Wash all parts except base.

Important: For warranty verification, please do not remove line cord sticker.

Note: Do not attempt to chop ice in this food processor; it will damage container and dull chopping blade. This unit will not whip cream, beat egg whites to

a desirable volume, grind coffee beans or spices with a high oil content, or slice or shred hard-cooked eggs, marshmallows, or soft cheeses.

CONTROLS

HIGH or LOW — When these buttons are pressed, unit runs continuously until OFF button is pressed.

OFF — Processor should always be left in OFF position when unit is not in use.

PULSE — PULSE button must be pressed and held for unit to operate. When released, unit will stop. Use PULSE for short processing tasks, such as chopping nuts, raw meats, or vegetables. This lets you check processed results and control the fineness.

Important: For your protection, this unit has an Interlock system. The processor won't operate unless container is properly locked onto base. Be sure to to attach the container to the base before attaching the food chute/cover. The tab on cover must be correctly locked into the slot on base. Be sure cover is turned fully into slot toward LOCK until you hear it click into place. Do not attempt to operate unit without container and cover correctly locked in place. Be sure base is on a flat, dry, clean surface before you begin processing.

SLICING/SHREDDING DISCS

Either the slice/shred disc or the extra-thin slice/fine shred disc may be used for slicing or shredding, depending on consistency desired.

1. Place container over center post in base with handle at left. Turn container toward base until it drops down into place.

Turn container counterclockwise until it locks into place

(Handle aligns with HIGH speed button) (A).

2. Place the disc stem onto the center post in the container,

A then grasp the slice/shred disc by its hub and push it down onto the disc stem.

For slicing - Slicing blade is raised (B).

For shredding – Shredding holes are raised (C).

B	3.	Place food chute/cover onto container with food tube to
		the left of the handle. Twist food chute/cover
		counterclockwise until you hear it click into place and
		LOCK. Arrow on handle aligns with arrow on the
C		chute/cover (D).
	4.	Plug cord into an electrical outlet. Use the Food Guide to
		help you prepare food for slice/shred processing.
	5.	Fill food chute with food and position the pusher over
		food.
D

3 4