Black & Decker 641915-00, FSCP200 instruction manual Problem Cause Correction

641915-00,FSCP200 Compressor 3/14/06 7:31 AM Page 17

	PROBLEM	CAUSE	CORRECTION
Motor will not		Motor overheated	Allow compressor to cool for
run.			approximately 30 minutes so
			thermal overload switch will
			reset. If unit still does not
			start, empty air from tank and
			refer to "Thermal overload
			protector cuts out
			repeatedly" information.
		Fuse blown, circuit breaker	Check fuse box for blown
		tripped.	fuse and replace as
			necessary. Reset circuit
			breaker. Do not use a fuse or
			circuit breaker with higher
			rating than that specified for
			your particular branch circuit.
			Check for proper fuse. You
			should use a time delay fuse.
			Check for low voltage
			problem.
			Check the extension cord.
			Disconnect the other
			electrical appliances from
			circuit or operate the
			compressor on its own
			branch circuit.
		Extension cord is wrong	Check the extension cord.
		length or gauge.
		Faulty motor.	Have checked by a Trained
			Service Technician.
Other			Contact a B&D sevice facility.

17