1Feature. On/offswitch
2.
3. Blade release button
4. Grass Shear blade (GSL35, GSL75, GSN30, GSN35)
5. Shrub Trim blade (GSL35, GSL75, GSN32, GSN35)
6. Blade cover (not shown)
1 2 3
5
4
Note: Noalignmentof blade withdrive | C |
pin is requiredandoperationof the blade |
|
cover releasebutton isnotrequired when |
|
1 | |
Charging Procedure |
|
Thebattery needs to becharged before | 2 |
firstuseandwhenever itfails toproduce |
|
sufficient power onjobs thatwere easily |
|
done before. When chargingthe battery |
|
forthefirst time, or after prolonged |
|
storage, itwill only acceptan 80% |
|
charge.After several chargeand dischargecycles, the battery will attain full | |
capacity.Thebattery maybecome warmwhilecharging;this is normal and | |
does not indicatea problem. |
|
Assembly
duringWARNINGassembly. : Avoid accidentally switching the tool on
WARNING: Do not charge the battery at ambient |
temperatures below 36° F (2°C) or above 104°F (40°C). |
Recommended charging temperature: Approximately 75°F (24°C). |
• Note:The charger plugincorporates lockouts to prevent the useof incorrect |
Fitting and removing the Thebladeshear(figblade. A, (4)B, hasC) been designed for trimming grass and weeds. The trim blade (5) has been designed for trimming hedges and shrubs.
• To remove the blade cover (6). Push and hold the blade release button (3) in the direction of the arrow (fig. A)
• Slide the blade cover (6) backwards and lift it off (fig.
• While holding the blade onto the pins (Fig. B), locatethe blade cover
(6) and slide it forward (fig. C).
A
1
2
B
• | chargers. The plugmust be correctlyoriented when inserted. | ||
Insert the charger plug into the charger connector at the rear of the | |||
| tool (fig. D). |
| |
• Plug the charger into a 120V outlet. | D | ||
• Charge the tool for 16 hours before first use. |
| ||
For catalo | numbers GSL35, GSL75: |
| |
• | The charger indicator light will come on |
| |
| indicating that the tool is charging. |
| |
• Whenthecharge is completethelightwill go out. |
| ||
For catalo | numbers GSN30,GSN32,GSN35: |
| |
• The charger indicator light will comeon indicating |
| ||
• | that the tool is charging. |
| |
The light will stay on as long as the charger is connected to the | |||
| tool and plugged into a working outlet. |
| |
• It WILLNOTflash, or goout when the chargingcycleis complete. To | |||
| maximize the lifetimeof the battery,it is recommendedto keep the battery | ||
connectedto the charger whenever the toolisnotin use. When the battery is | |||
| full,the powerconsumptionof the charger isnegligible. |
4