Figure F depicts the rear handle in 90° left (f1), 0° (f2) and 90° right (f3) positions.
F |
f1 |
4.LEVEL HEDGES (Figure I) – To obtain exceptionally level hedges, a piece of string can be stretched along the length of the hedge as a guide.
I |
f2 |
f3 |
TRIMMING INSTRUCTIONS
1.EXTENSION CORD – (Figure G) Always keep
extension cord behind trimmer and away from the | G |
trimming operation. Never drape it over a hedge being | |
trimmed. If you cut or damage the cord, unplug it at the |
|
electrical outlet immediately, before inspecting or |
|
repairing cord. |
|
2. WORKING POSITION – Maintain proper footing and |
|
balance and do not overreach. Wear safety goggles, |
|
| |
Hold the tool firmly in both hands and turn the tool ON. |
|
Always hold the trimmer, as shown in figure G, with |
|
one hand on the switch handle and one hand on the |
|
bail handle. Never hold the tool by the blade guard. |
|
3.TRIMMING NEW GROWTH - (Figure H) – A wide,
sweeping motion, feeding the blade teeth through the | H |
twigs is most effective. A slight downward tilt of the |
|
blade, in the direction of motion gives the best cutting. |
|
CAUTION: Do not use the trimmer for cutting stems greater than 3/4 in. (19mm). Use the trimmer only for cutting normal shrubbery found around houses and buildings.
6
5. | Begin at the bottom | J |
and sweep up. |
|
WARNING: TO GUARD AGAINST INJURY, OBSERVE THE FOLLOWING:
• READ INSTRUCTION MANUAL BEFORE USING, SAVE INSTRUCTION MANUAL.
• CHECK THE HEDGE FOR FOREIGN OBJECTS SUCH AS WIRE OR FENCES BEFORE EACH USE.
•KEEP HANDS AWAY FROM BLADES.
•KEEP HANDS ON HANDLES. DONʼT OVERREACH.
• CAUTION: – BLADE COASTS AFTER TURN OFF.
•DO NOT USE UNDER WET CONDITIONS.
•DO NOT USE WITH DAMAGED EXTENSION CORD.
•DO NOT UNPLUG OR STORE WITH SWITCH LOCKED ON.
DANGER: KEEP HANDS AWAY FROM BLADES.
CAUTION: BLADE COASTS AFTER TURN OFF.
TROUBLESHOOTING
Problem | Possible Cause | Possible Solution |
• Unit will not start. | • Cord not plugged in. | • Plug tool into a working |
|
| outlet. |
| • Circuit fuse is blown. | • Replace circuit fuse. |
|
| (If the product repeatedly |
|
| causes the circuit fuse to |
|
| blow, discontinue use |
|
| immediately and have it |
|
| serviced at a Black & |
|
| Decker service center or |
|
| authorized servicer.) |
| • Circuit breaker is tripped. | • Reset circuit breaker. |
|
| (If the product repeatedly |
|
| causes the circuit |
|
| breaker to trip, |
|
| discontinue use |
|
| immediately and have it |
|
| serviced at a Black & |
|
| Decker service center or |
|
| authorized servicer.) |
| • Cord or switch is damaged. | • Have cord or switch |
|
| replaced at Black |
|
| & Decker Service Center |
|
| or Authorized Servicer |
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at
7