Black & Decker JC120 manual Before first use, English

•Connect the blue lead to the neutral terminal

•If the product is class I (earthed), connect the green/yellow lead to the earth terminal.

Note: If your product is class II double insulated (only 2 wires in the cord set), no connection is to be made to the earth terminal.

Follow the fitting instructions supplied with good quality plugs

Any replacement fuse must be of the same rating as the original fuse supplied with the product.

Warning! The above section on mains plug replacement is for authorized service centre personals.

Before first use

•Remove all packaging from the appliance.

•Clean the appliance before first use.

•Fill the kettle with cold water to the maximum fill mark. Do not over fill as described below.

•Close the lid (1). Boil the water as described below.

•Discard the boiled water and repeat the procedure.

Use

Warning! Always place the appliance on a flat, clean and non-slip surface before operating it.

Warning! Always allow the product and contents to cool before opening the lid / re-filling.

ENGLISH

Warning! Always check the water level while using the appliance. Never use the appliance without sufficient water.

Warning! Steam may escape from the spout.

Warning! This Kettle must only be used with the Kettle base provided.

•Place the kettle base (5) on a suitable surface.

•Take the kettle to a water outlet. Open the lid

(1).

•Fill the kettle with cold water to the desired level.

•To prevent dry-boiling fill to at least 250 ml (one cup).

•Do not fill the kettle beyond the maximum fill mark. If the kettle is overfilled, boiling water may be ejected from the pouring spout (3).

•Close the lid (1) and make sure it snaps into place.

•Place the kettle on the kettle base (5).

•Insert the plug into a suitable electrical outlet and push the on/off switch (2) to the on position (I).

•The power on indicator (2) will light.

•The water will start boiling, making a rumbling noise. Do not open the lid when the water is boiling.

•As soon as the water has boiled, the appliance will switch off and the power on indicator (2) will go out.

•Always ensure the Kettle has turned off before lifting it from the Kettle base.

5