and can cut you when it is not running. |
|
| |
WARNING: Burn hazard. The chain guide bar and chain may | |||
become hot during use. Allow to | F | 1 3 | 14 |
cool before adjustment or | |||
removal. |
|
|
|
- Place the tool on a firm surface. |
|
|
|
in the nose sprocket of the chain bar. Make sure chain is installed properly, with the cutting teeth facing forward as shown here.
- Rotate the two retention bolts |
(11) counter clockwise with |
wrench (12) provided and remove |
completely. |
- Remove the chain access |
cover (13). |
- Open the handles and pull back |
the top chain cover jaw (1). |
- Pull back chain bar (3) and then lift the saw chain (14) out of the |
groove in the guide bar. The chain (14) can then be removed from |
the unit. |
- The chain bar can then be angled up. |
Assembling the chain bar and chain (figs. G, H) |
WARNING: Before chain or other adjustments, make sure |
that the battery is disconnected from the tool. |
-Pull the chain bar and chain back, engaging it in the groove in the chain bar and then over the sprocket (15) positioning teeth in the correct position on the sprocket.
-Replace the chain access cover (13) and retention bolts (11) tightening securely.
H |
|
|
|
15 | 14 | 15 | 14 |
WARNING: Always wear | G |
protective gloves when installing or | |
removing the saw chain. The saw | 3 |
chain is sharp and can cut you | 1 |
when it is not running. | |
- Ensure the operation is carried |
|
out on a firm surface. |
|
- Open the handles and pull back |
|
the top jaw (1). |
|
- Insert the chain bar into the |
|
space between the chain tensioner |
|
and align with the chain bar |
|
locator, angle the chain bar down ensuring it is correctly located. | |
- Place the chain (14) around the front of the chain bar and engage | |
Operation
Never operate a chain saw that is damaged or improperly adjusted or that is not completely and securely assembled. Be sure that the saw chain stops moving when the power control system triggers are released. Never adjust the guide bar or saw chain when the engine is operating.
WARNING: Let the tool work at its own pace. Do not overload. - Carry out regular cleaning of the unit as described in the maintenance section and in particular cleaning inside the chain access cover.
- The lower guard jaw (2) and top jaw (1) are designed to close when one of the handles is released or when the piece of branch being cut has been cut. If this does not occur, discontinue use of the tool and remove the battery pack. Check if any debris is blocking movement. To help in this process it may be necessary to remove chain access cover(13). If on assembly the problem is still present
11 take the unit to a service center.
