![](/images/new-backgrounds/1114229/11422919x1.webp)
Installing / Removing Battery Pack WARNING: Make certain the
prevent switch actuation before removing or installing battery.
replaced. Contact your nearest service center.
The product comes ready assembled. However we recommend that you check the tension of the chain, and chain retention bolts before use and if required adjust.
To install battery pack: Insert battery pack into tool until an audible click is heard (figure C).
To remove battery pack: Depress the battery release button in the back of the battery pack and pull battery pack out of tool.
C |
Checking and adjusting the chain tension (figs. D, E) | ||
To tension the chain slacken the | D |
|
two chain cover retention bolts | 12 | |
(11) with the wrench (12) and the | 13 11 | |
atuomatic chain tensioning device |
| |
(fig E) will push the chain bar |
|
|
out, setting the correct tension. |
|
|
Retighten the two retention bolts |
|
|
(11) securely. |
|
|
Check that the correct tension has |
|
|
been set by lightly pulling on the |
|
|
chain. The tension is correct when |
|
|
the chain snaps back after being |
|
|
pulled 1/8 inch (3 mm) away from | E |
|
the guide bar. There should be no |
|
Preparing AlLigator Lopper For Use
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury
WARNING: Sharp moving blade. To prevent accidental operation, ensure that the battery is disconnected from the tool before performing the following operations. Failure to do this could result in serious personal injury.
CAUTION: Sharp moving blade. Always wear protective gloves when installing or removing the chain. The chain is sharp and can cut you when it is not running.
Chain tension adjustment
WARNING: Before chain or other adjustments, make sure that the battery is disconnected from the tool.
If the chain cannot be correctly tensioned, it may need to be
“sag” between the guide bar and |
chain on the underside. |
Note: Do not over tension the chain |
as this will lead to excessive wear |
and reduce the life of the bar and |
chain. It will also lead to reduced |
product performance. |
Note: With first use and when the chain is new, check tension |
frequently as a new chain stretches slightly. |
Replacing the chain and chain bar
After prolonged use the chain and / or chain bar may need replacing. Use Black+Decker replacement chain RC600 only.
10