Components
Functional Description | 5. | Latch | |
(Fig A) | |||
1. | Top jaw | 6. | Battery Pack |
2. | Lower jaw | 7. | On/off switch actuators |
3. | Chain guide bar | 8. | Chipping ejection point |
4. | Oiling cover | 9. | Charger |
A |
•Do not expose charger to rain or snow.
•Pull by plug rather than cord when disconnecting charger.
This will reduce risk of damage to electric plug and cord.
•Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
•Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.
•An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.
Recommended Minimum Wire Size for Extension Cords
• Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.
• Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug — have them replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.
|
|
| |||
Volts |
| Minimum Gauge for Cord Sets | |||
| Total Length of Cord in Feet | ||||
120V |
| ||||
|
| ||||
Ampere Rating | American Wire Gauge |
| |||
More | Not more |
| |||
Than | Than | 18 | 16 | 14 | 12 |
6 - | 10 | ||||
7
