FUNCTIONAL DESCRIPTION
1.Switch
2.Battery
3.Auxillary Handle
4.Collar (to adjust height and edge)
5.Motor Housing
6.Edge Guide
7.Guard
8.Spool
1
2
3
4
5
7
Charging Procedure 1
The standard charger provided will
charge a fully depeleted battery in about 4 hours.
1. Plug the charger into an appropriate outlet before inserting
the battery pack.
2. Insert the battery pack into the
charger as shown in figure 1.
3. The green LED will flash indicating that the battery is being charged.
4. The completion of charge is
indicated by the green LED remaining on continuously. The pack is fully charged and may be used at this time or left on the charger.
Recharge discharged batteries as soon as possible after use or battery life may be greatly diminished.
Leaving the battery in the charger
The charger and battery pack can be left connected with the green LED glowing indefinitely. The charger will keep the battery pack fresh and fully charged.
This product can accept any of the | 6 | 8 |
batteries and chargers listed in the |
|
|
chart below. |
|
|
|
| |
Description |
| Cat. # |
Batteries: |
| LBX20 |
|
| LBXR20 |
|
| LBXR2020 |
|
| LB2X4020 |
Chargers: |
| LCS1620 |
|
| L2AFCBST |
|
| L2AFC |
Important Charging Notes
1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 60°F and 80°F (16°- 27°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
6
