![](/images/new-backgrounds/1105721/10572123x1.webp)
• Insert the 3/4 inch (19mm) | u | t | |
end of the bulk line into the | 16 |
| |
hole (t) in the spool |
|
|
|
adjacent to the slot as |
|
|
|
shown in figure 16. |
|
|
|
• Wind the cutting line onto the spool in | 17 |
the direction of the arrow on the spool. |
|
Make sure to wind the line on neatlyand |
|
in layers. Do not crisscross(figure 17). |
|
• When the wound cutting line reaches |
|
the recesses (u), cut the line. (figure 16). |
|
• Fit the spool onto the tool as described |
|
in “REPLACING THE SPOOL”. |
|
THE RBRC™ SEAL |
|
The RBRC™ (Rechargeable Battery Recycling | |
Corporation) Seal on the | |
indicates that the costs to recycle the battery (or battery | |
pack) at the end of its useful life have already been paid | |
RBRC™ in cooperation with Black & Decker and other battery users, | |
by Black & Decker. |
|
has established programs in the United States to facilitate the | |
collection of spent |
conserve natural resources by returning the spent | ||
an authorized Black & Decker service center or to your local retailer | ||
for recycling. You may also contact your local recycling center for | ||
information on where to drop off the spent battery. RBRC™ is a | ||
registered trademark of the RechargeableBattery Recycling | ||
Corporation. | MAINTENANCE | |
WARNING: | ||
To avoid serious injury, remove the battery from |
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition, store spare
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is recommended you periodically
IMPORTANT:To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.
TROUBLESHOOTING
TOOL RUNS SLOWLY
• Check that the spool housing can rotate freely. Carefully clean it if necessary.
• Check that the cutting line does not protrude more than approximately
AUTOMATIC LINE FEED DOES NOT WORK
• Keep the tabs depressed and remove the spool from the spool
12 housing in the trimmer head.