Black & Decker PRSM600 manual English, Figure E Using the Cookie shape selector

English

Holding the release button (6) down, fit the assembled Mincer (21) into the hole, and turn it to make sure the flat on the end of the screw engages in the slotted coupling. Release the button, & rotate the Mincer assembly again. The screw should be connected to the coupling. When the pin on the release button aligns with the hole in the Mincer, the spring will push the pin through, locking it in place.

The feeder tube should be facing up. Fit the tray (30) into the feeder (31) in the Mincer head.

Remove the nut (23) by rotating it in an anti-clockwise direction. The spanner (29) may be required. Remove the round die (25 or 26) & replace with the one required for the task. Locate the cut-out in the die with the tab on the Mincer head. Replace the nut. Place the ingredients on the tray, and a bowl under the Mincer head.

Connect the appliance to a suitable electrical supply.

Rotating the control dial clockwise, select a slow speed. Using the pusher (28), push the ingredients into the hole in the tray & down into the Mincer.

The screw will collect the ingredients, compressing them & moving them forward. The blade will cut the ingredients, which will then be forced through the die and fall into the bowl.

Never insert fingers into the feed chute. Only use the pusher provided.

Never approach any moving parts until they have come to a complete stop.

The tray (27) can be used as lid on plastic

bowl (30) making it a storage bowl.

Figure E: Using the Cookie shape

selector:

Place the Mixer on a flat surface.

Ensure the Mixer head (1) is locked in the horizontal position.

Press the attachment release lever (6) down and Lift the front cap (9) to reveal a hole and slotted coupling.

Holding the release button (6) down, fit the Mincer (21) into the hole, and turn it to make sure the flat on the end of the screw engages in the slotted coupling. Release the button, & rotate the Mincer assembly again. The screw should be connected to the coupling. When the pin on the release button aligns with the hole in the Mincer, the spring will push the pin through, locking it in place.

The feeder tube should be facing up. Fit the tray (23) into the feeder (31) in the Mincer head.

Remove the nut (23) by rotating it in an anti-clockwise direction. The spanner (29) may be required. Remove the round die (25 & 26) and blade (22).

Place the cookie cup (32) (without shape selector (33)) in the nut, and fasten it back onto the Mincer head.

Fit the shape selector through the 2 slots in the cookie attachment. Fit the tray (27) into the vertical tube (31) in the Mincer head.

-10-