724-746-5500 | blackbox.com
Page 22
724-746-5500 | blackbox.com
Chapter 4: Service Setup
4.0 Service Setup
For standard applications, you should not need to make any adjustments to your DVI-D KVM Extender. However, in certain
circumstances, you may need to open the Local Unit and/or the Remote Unit. To open one of the units, unscrew the Philips-type
screws at both sides at the bottom of the device. Unscrew the UNC-type screws on each side of the monitor connectors. Carefully
separate the lower and upper shells of the case.
Fastening screws
on the base.
Fastening screws
on the base.
Figure 4-1. Location of fastening screws.
4.1 Setup at the Local Unit
After unscrewing and opening the upper shell, place the device so the CATx connectors are on the right and the electrical
connectors are on the left. The main circuit board then will look like this:
Location of jumpers:
indicated as JP1, JP3, JP3.
Figure 4-2. Schematic of the interior of the local unit. Note the position of the jumpers.
ACS4002A-R2